Manual tap, G 1/2", 2-piece, DIN 5157

GEW H G12

Exemplary representation: Manual tap set
pcs
{{ $t('shop.display.artikel.hinweis_alternative') }}
{{ $t('shop.display.artikel.beschreibung_headline') }}
Description:
2-piece manual tap set, comprising pre-cutter and finish cutter for G-thread in accordance with DIN ISO 228 and Rp-thread in accordance with DIN 2999. Flanks relief ground, tolerance in accordance with ISO 2 / 6H, gate cut: 2 - 3 turns.

Quality:


HSS-G:
Use for steel, cast steel alloys and non-alloys (<800 N/mm² tensile strength), grey-, malleable-, ductile-, cast and sintered iron, nickel silver, graphite and short cutting aluminium alloys, brass and bronze.
{{ $t('shop.display.artikel.eigenschaften_headline') }}
Thread G 1/2"
Core hole diameter [mm] 19,00
Square (DIN 10) [mm] 12,0
GEWHG12
{{ $t('shop.all.gewicht') }} 270 g / pcs
{{ $t('shop.display.artikel.zollwarennummer') }} 82074010
{{ $t('shop.all.dokumente') }}

 
{{ $t('shop.all.unverbindliche_richtwerte') }}

Accessories

{{ $t('shop.all.spaetbestellservice') }}
{{ countdownAsString }} {{ $t('shop.modules.navi.fruehbucher-spaetbestellhinweis.noch') }}
{{ $t('shop.modules.navi.fruehbucher-spaetbestellhinweis.noch') }} {{ countdownAsString }}

{{ $t('shop.all.spaetbestellservice.hinweis') }}

{{ $t('shop.all.wochenendversand') }}
{{ $t('shop.modules.navi.fruehbucher-spaetbestellhinweis.noch') }} {{ countdownAsString }}

{{ $t('shop.all.wochenendversand.hinweis') }}

An error has occurred!

An error has occurred, please reload this page and try again.